Hi
Can anyone out there tell me how to get a Volt into a mode where we can use it on a dynamometer? We'll need to disable the traction control, which we'd normally do by removing the fuse, but the Volt we're working on won't drive without it!
Any suggestions appreciated. I'm working with one of the very few Volts in Europe, so local advice hard to come by.
Many thanks,
Ruth
Can anyone out there tell me how to get a Volt into a mode where we can use it on a dynamometer? We'll need to disable the traction control, which we'd normally do by removing the fuse, but the Volt we're working on won't drive without it!
Any suggestions appreciated. I'm working with one of the very few Volts in Europe, so local advice hard to come by.
Many thanks,
Ruth