I know some of you have done the self install for the Voltec charger, so hopefully one of you can answer a quick question for me about where to connect the wiring to the Voltec charger.
So through my EMT conduit from my home's electrical box, I have three, 12 gauge wires. Two "hot wires" coming out of my 20A, dual pole breaker, and a white common wire coming from the common bar (not sure what it is called) in my electrical box.
So those 3 wires mentioned above get fed into the Voltec charger. Per the picture I have linked and inserted, on the left bottom side of the Voltec charger (assuming you're holding it upright), there are 5 pairs of screws (as pictured).
Ok, so here's the question before I wire it and mess it up The two leftmost pairs of screws I ASSume are not used at all. The bottom 3rd and 4th screws from the left (with the red and black wires opposite them in the picture) are the ones I ASSume the two hot wires (from the dual pole breaker) get connected to. The 5th screw from the left (the one with the green wire opposite it) is the one where the white, common wire gets connected to.
Are my assumptions correct?
picture of screws in question: