I was debating whether or not to mod my gen2 to avoid ERDTT, and wasn't planning on doing it since its been relatively warm this winter...only had 3 days where it was cold enough to trigger.

That being said, I may do it in the coming weeks anyway just to avoid the engine from firing up during 'milk runs' around the corner, which is my biggest annoyance.

There is a tonne of pictures and info for how to get at the sensor on gen1 and what resistor value to use, but I cant seem to find the same amount of information on the gen2. Anyone know of a thread where this was discussed in detail with (hopefully) some pictures/instructions?